Brus drying: methods, stages and recommendations
To dry the beam, you need to make a lot of effort. Previously, the beam was sorted out a couple of years in a ventilated room or under a canopy; Between separate bars were put on gaskets, and the ends were smeared. Nevertheless, it was sometimes possible to prevent warrings: the beam was bending an arc, turned or covered with cracks. Since the beam is rather large enough thickness, it dries agilely at the plane, remaining raw snuff. As a result, stress arises between different shares, and the beam “leads” (which is actually especially noticeable during the period of increased drying in the drying chamber).
Typical length of the beam – 5 meters; A beam of other volumes is made by personal order. You can order the section you need, although you need to pay in addition for this.
If you use a raw profiled beam, it is possible to get rid of some flaws. Namely, from the need for subsequent decoration, because the profiled beam has a demanding geometric shape, and its planes are processed with a special device to the first class of cleanliness, t. e. to the value of the Eurolinka. Although, since this material is also large, there is a risk that the bar will be able to “story” during the period of drying out. Prof. Drying technologies make it possible to find a dry profiled beam, which is least of holistic building materials is subject to destruction and warfare. But the absolute solution of difficulty is likely only if the glued profiled timber is used.